Difference between revisions of "RaspberryPi Boards"
Lo-tech>James (Added VGA Adapter) |
(Updated GPIO board link) |
||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 6: | Line 6: | ||
== GPIO Interface Board == | == GPIO Interface Board == | ||
| − | The '''Lo-tech GPIO Interface Board''' is a general-purchase, GPIO interface for use with the RaspberryPi Model A+, B+ and 2B single-board computers. The boards follow the dimensions of the Rapsberry Pi HAT specification. | + | The '''[[Lo-tech GPIO Interface Board rev.2|Lo-tech GPIO Interface Board]]''' is a general-purchase, GPIO interface for use with the RaspberryPi Model A+, B+ and 2B single-board computers. The boards follow the dimensions of the Rapsberry Pi HAT specification. The board provides:4x opto-isolated inputs, 8x open-collector outputs (up to 30V/200mA), Maxim 1-wire bus connection, and Fused 5V power header (for powering the Raspberry Pi). |
| − | + | == 24-bit VGA Adapter == | |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | + | The [[Lo-tech RPi VGA Adapter PCB]] provides a secondary display option for Raspberry Pi SBCs equipped with the 40-pin GPIO header. The boards follow the dimensions of the Rapsberry Pi HAT specification and is natively supported in Raspbian Jessie via the dpi24.dtb overlay - no drivers are required. | |
| − | The [[Lo-tech | + | == PDT RollerTec Interface == |
| + | The [[Lo-tech PDT RollerTec Interface]] is a PCB set than enables a RaspberryPi to monitor and operate the PDT RollerTec garage door controller. A HomeBridge plugin is also provided - this set brings 'Hey Siri!' to this popular garage door system. | ||
== See Also == | == See Also == | ||
Latest revision as of 07:34, 25 April 2021
Lo-tech boards designed for use with the Raspberry Pi hardware.
Note that Lo-tech boards are designed independently of, and in no way endorsed by, the Raspberry Pi Foundation. 'Raspberry Pi' is a trademark of the Raspberry Pi Foundation.
GPIO Interface Board
The Lo-tech GPIO Interface Board is a general-purchase, GPIO interface for use with the RaspberryPi Model A+, B+ and 2B single-board computers. The boards follow the dimensions of the Rapsberry Pi HAT specification. The board provides:4x opto-isolated inputs, 8x open-collector outputs (up to 30V/200mA), Maxim 1-wire bus connection, and Fused 5V power header (for powering the Raspberry Pi).
24-bit VGA Adapter
The Lo-tech RPi VGA Adapter PCB provides a secondary display option for Raspberry Pi SBCs equipped with the 40-pin GPIO header. The boards follow the dimensions of the Rapsberry Pi HAT specification and is natively supported in Raspbian Jessie via the dpi24.dtb overlay - no drivers are required.
PDT RollerTec Interface
The Lo-tech PDT RollerTec Interface is a PCB set than enables a RaspberryPi to monitor and operate the PDT RollerTec garage door controller. A HomeBridge plugin is also provided - this set brings 'Hey Siri!' to this popular garage door system.